Killingly has 7,678 homes, and half of them were standing by 1968. The rules below decide how much of the old roof has to come off and what goes under the new one.
New Roofing Costs connects homeowners with independent local roofing contractors. We do not perform roofing work.
This number connects homeowners who are planning a new roof or a full roof replacement with independent local roofing contractors. It is not for leak repairs or patch jobs. The call must come from the homeowner who decides on the roof. Calls may be recorded.
Permit
Without a permit, Connecticut allows only:
Repairs that are limited to 25 percent of roof covering and building siding within one calendar year.
2022 CSBC, (Amd) R105.2, item 11
A full replacement in Killingly is past that line; the town building official issues the permit.
Layers
On a roof that already carries two layers, or slate or tile, the code allows no recover: it is a tear-off (IRC R908.3.1.1). 68% of Killingly’s homes were built before 1980, so count the layers before comparing quotes.
Source: IRC 2021, Chapter 9 (Pennsylvania edition, UpCodes); 2022 Connecticut State Building Code
Ice barrier
The state’s climate table marks the ice barrier “yes” statewide. It runs from the eave to 24 inches inside the exterior wall, more on steep roofs (IRC R905.1.2); check that the quote lists it.
Source: 2022 Connecticut State Building Code; IRC 2021, Chapter 9 (Pennsylvania edition, UpCodes)
Deck joints
Connecticut adds a 4-inch self-adhering strip over all joints of a plywood or OSB deck ((Amd) R905.1.1). It is not needed under a fully adhered membrane, or on board decks under 3 feet wide.
Wind and snow
Killingly’s code design values are a 125 mph ultimate design wind speed and a 35 psf ground snow load; it is in Connecticut’s hurricane-prone region. At that wind speed the code calls for asphalt shingles labeled ASTM D7158 Class G or H (Table R905.2.4.1).
Source: 2022 Connecticut State Building Code; IRC 2021, Chapter 9 (Pennsylvania edition, UpCodes) (2022 CSBC, Appendix AY)
Rules as read on October 24, 2026. The state’s code edition and the rest of its rules: roof replacement in Connecticut.
Of 7,300 occupied homes in Killingly, 5,229 (72%) are owner-occupied. By year built, 23% before 1940, 40% before 1960, 68% before 1980; 15% went up in 2000 or later. (ACS 2020–2024.)
By building type: 66% detached houses, 4% attached single-family houses (rowhouses, twins and townhouses), 15% buildings of two to four units.
Of the 15 Windham County municipalities on this site, Killingly has the 4th largest share of homes built before 1980: 68%, against a county range of 38% to 81%.
ZIP codes: 06239 · 06241 · 06243 · 06263
| Place | Median built | Before 1980 | Owners | Row, twin | Hail days |
|---|---|---|---|---|---|
| Killingly | 1968 | 68% | 72% | 4% | 4 |
| Putnam | 1961 | 71% | 60% | 6% | 8 |
| Brooklyn | 1978 | 52% | 82% | 3% | 4 |
| Pomfret | 1978 | 53% | 81% | 1% | 6 |
| Sterling | 1988 | 38% | 81% | 8% | 7 |
| Plainfield | 1971 | 68% | 74% | 5% | 5 |
Median built: median year the homes were built. Before 1980: share of homes built then. Owners: share of homes that are owner-occupied. Row, twin: share of homes that are rowhouses, twins or townhouses. Census ACS 2020–2024. Hail days: days with hail of 1 inch or larger within 10 miles, 2006–2025, NOAA Storm Prediction Center.
NOAA’s storm reports show 4 days since 2006 with hail of at least 1 inch inside a 10-mile circle around Killingly, topping out at 1.75 in on July 3, 2025.
That is fewer than most places in the state on this site (median 9 days).
Federal major-disaster declarations for storms in Windham County since 2006: 8, most recently DR-4580, Tropical Storm Isaias, declared January 2021. (OpenFEMA.)
A report says hail fell near Killingly, not that it damaged a roof. When wind or hail damage means a new roof.
Useful life is HUD’s planning figure, not a warranty. More in the guides to shingles, metal, slate and flat roofs.
| Material | HUD useful life | Fits a house like | Watch for |
|---|---|---|---|
| Asphalt shingles | 20 years | Most pitched roofs; 66% of homes here are detached | Class G or H at 125 mph design wind (IRC Table R905.2.4.1) |
| Metal (standing seam, panels) | 50 years | Low pitches and long runs | Standing seam that carries its own loads can skip the tear-off (R908.3.1) |
| Slate | 75 years | Older houses; 23% here predate 1940 | Can’t be roofed over; check the framing for the weight |
| Flat roof: EPDM or TPO | 15 years | Porches, additions, low-slope rears | Seams at walls and drainage |
Whoever quotes a roof in Killingly should give you a Connecticut home improvement registration number (C.G.S. § 20-420); the state’s data portal listed 24,065 active ones in October 2026. Registration is not an endorsement of workmanship (§ 20-427(b)(6)).
The price side is in what a new roof costs in Connecticut; the paperwork side in checking a roofing contractor.
A permit from Killingly. A full replacement in Killingly is past that line; the town building official issues the permit.
On a roof that already carries two layers, or slate or tile, the code allows no recover: it is a tear-off (IRC R908.3.1.1). 68% of Killingly’s homes were built before 1980, so count the layers before comparing quotes.
By the Census Bureau’s American Community Survey (2020–2024), the median home in Killingly was built in 1968, 68% of homes were built before 1980, 72% are owner-occupied.
Hail of 1 inch or larger was reported on 4 days within 10 miles of Killingly from 2006 through 2025 (NOAA Storm Prediction Center). A report means hail fell nearby, not that a roof was damaged.
Whoever quotes a roof in Killingly should give you a Connecticut home improvement registration number (C.G.S. § 20-420); the state’s data portal listed 24,065 active ones in October 2026. Registration is not an endorsement of workmanship (§ 20-427(b)(6)).
The full list: before you call.
Checked October 24, 2026. Laws and code editions change; the date says when these were last read at the source.